This is our idea of the correct way to make an Offset Panhard / Trackbar bracket, it seems like 3 out of 4 need to be on the leading edge of the axle for clearance issues. The center of the heim will be 6", 7" or 8" vertically from the center of the axle tube and 3.5" forward of the center of the axle tube. They are cut to fit a 3" axle tube so they can be modified to fit any tube diameter, fabricated from 1/4" plate, and bent perfectly so you don't have to play with the grinder to make them fit! They have two drain holes built in. These are setup for a 2" ID and have 5/8 inch bolt holes so just about any heim will fit with minimal misalignment.