Jeep TJ, LJ, MJ, XJ, and ZJ Front Axle Coil Spring Brackets

I purchased the TJ front axle coil spring brackets for my 03 Rubicon because of rust damage to my originals. The kit arrived and I was very impressed with the fast shipping, but mostly the high quality of the parts. Of course you must be prepared to weld everything together yourself, but the bends and radii of cutouts to fit the axle tubes are perfect. The components are thicker gauge than stock, but mesh perfectly with the factory lower control arm brackets (which I kept) and the "caster" angle is "right on" with no adjustment necessary. I made a "gauge" to indicate the factory track bar location before I cut the original damaged bracket off, then used it to locate the new Barnes passenger bracket side-to-side placement so that the track bar mount was exactly where the factory location was, and I was able to bolt up my original track bar. The original steering stabilizer also fit perfectly. All the factory bolts fit nicely by the way. This kit changes the lower shock mount method from a two hole bar to a bolt stud mount. I cut the bar tab off my original shocks, but when I tried to fit the shock into the new brackets the shock body (original factory units) interfered with the shock mount plates in the bracket. I had to grind the two shock mount plates down a little bit to allow room for the shock tube. Not a big deal. All in all I'm extremely pleased these parts are available and I believe they are a great bargain. I'm getting some more life out of my Rubicon!

I bought these to replace rusty coil bucket on a 98 XJ. While at first I thought they were a little pricey (buying from Canada), it was clear upon arrival that these were a high quality product. I liked that these retained the factory mounting brackets for the track bar, steering stabilizer, and sway bar. The assembly instructions on the Barnes website are clear and very easy to follow. Installation was straight forward and everything bolted back up as it should. Excellent!!!

I bought these for a front dana44 swap for a 2000 tj. So far they are very heavy duty. With a little fab work i can make them fit. Retains factory suspension brackets too! Perfect piece if your trying to do a budget axle swap

great product