Q: Do these come with instructions how to install? Is there any other parts needed for this install?
A: This kit does not include any instructions. This kit is a DIY kit that is intended to be a base for building a custom long arm suspension for the front of your Jeep. All of the components are included for the front suspension on a Jeep TJ, other components may be needed for your particular installation depending on how you decide to setup your suspension.
Q: Can't you offer this kit with the option of upper heim or Eduro joints?
A: Thanks for the question. We can set up a kit to your specifications. Just give us a call and we can piece together a kit for you in no time. 828-551-7616
Q: Does this fit the rear of a jeep tj or only the front ?
A: This kit is designed to be used on the front of a Jeep TJ.
Q: Will this kit work with your Dana 60 conversion kit?
A: Everything would work except you may run into some issues with the short radius links coming into contact with the truss top. We have not tested this yet but we know it is an issue with other manufacturers.
Q: will this work on a wj with 12inch lift ?
A: Since this is a radius arm kit we would not recommend it be used on a WJ since they have independent control arms, if you are looking for a 4 link for that vehicle I'd recommend one of our universal kits.
Q: I can't tell if the upper link to the axle is a bolt on to the original Dana 30 brackets or are they weld on. I know this is a builders kit but i am curious what the bracket is for on the upper arm, axle end is for.
A: As of 11/10/2020 all of our brackets are weld on.
Q: I was wondering what width the frame side brackets are for the diy front long arm upgrade kit because I would want to upgrade them to either heim or joint instead of bushing for better articulation
A: They are 2 5/8" mounting width with a 9/16" bolt hole
Q: What is the length of the arms? I'm looking for a 36" arm to complement a 6.5" lift. Thanks!
A: This comes with two 3 Ft Sections Of 2" O.D. 1/4" Wall DOM.