If you are looking to install our Jeep JK 3 link suspension system and you do not have a truss on your axle, this is the perfect solution for your front upper suspension link. We built this bracket to be a companion to our front upper 3 link suspension frame bracket, for a perfect fit and perfect suspension joint alignment every time. Brutally strong 1/4 inch thick steel is used to manufacture this bracket for the ultimate in strength. All components of this kit key together for ease of assembly and accuracy, the radius is cut to be a perfect fit on your axle tube to provide the correct angle for your installation. This bracket is designed to use a suspension joint with a 2-5/8 inch mounting width and a 9/16 inch bolt. This product requires welding and general fabrication skills for installation, mounting hardware for the suspension joint is included. Designed to fit a 3-3/4 inch diameter axle tube, this will fit all 2005-Up Ford Superduty Dana 60 model axles that have been swapped into 2007-2018 Jeep JK and JK Unlimited vehicles.