Q: How wide is this bumper? I already asked about the weight I believe your awnser was 48 lbs
A: Hello Clayton,
The overall weight is 95 lbs. The overall width is 55.25" inches. Thanks for the question!
Q: Beautiful bumper! This is very close to what I’ve been looking for. Can you advise approximate dimensions of the inside of the bull bar/hoop portion of the bumper? I have three Rigid R46 lights that measure just under 6” in diameter, and I would like to mount them on the bumper UNDER the hoop, so they are surrounded. Would this be possible?
A: Thank you! So the measurement between the bottom of the bar to the top plate of the bumper is around 4 1/8". So we don't think that would work, especially three of them. However there are provisions for mounting them on top of the bumper.
Q: The last few times I have checked your site this bumper has stated that it is not for sale. Is this something that you are going to manufacture again or is it being discontinued?
A: On our website when a product is "NOT FOR SALE" it is currently out of stock.
Q: I can see the bumper is wider than the grille. What is the actual width?
Q: I was just curious if you could put fog lights into the dimple's that are pressed throughout the bumper? I know that the fogs can be implemented in the frame chop front bumper so I was curious is the same could be applied with this front bumper? Also, if fog lights can be implemented on this bumper please include how. Such as mounts needed to be fabricated and what size lights I would need to look for to be able to use them. I was hoping to put the Baja Design lights in this bumper. Thanks
A: No they can only be mounted on top. The factory mounting locations are in the way of any internal lights. With the frame chop the factory mounting locations are removed, this is one of the main benefits of the frame chop in my opinion. A more compact front end with recessed lights is a good look.
Q: When will this item be in stock again?
A: Hopefully within the next week.
Q: Is this bumper winch ready, or will you need to order the mounting plate and fairlead? Thank you!
A: Yes this bumper has built in provisions for mounting a winch and fairlead. Please refer to the description and the installation instructions for the type of winch it is compatible with.
Q: Can you put dog lights in this bumper?
A: Lights can only be installed in the frame chop bumper. This option requires the lights be installed on top.
Q: Will this fit on a 2021 gladiator sport s max tow? It's not listed?
A: No this Bumper is for a jeep JK I would check out part number B4WK12338 for a JT
Q: How much does this bumper weigh?