Heim Joints 101
We get a lot of questions
about Heim Joints, they are well warranted. There is a lot of information to
know about the different options, and dimensions of heim Joints we carry here
at Barnes4wd. So let’s start off with the most important question what is a
heim joint?
I could give you a
definition off the internet or out an automotive dictionary. Those kind of
technical definitions have never really helped me. My definition is for those
of us that are newbies to the 4wd world. Any of you veterans that can add input
it’s definitely welcomed. A heim Joint is a Threaded rod with a circular top,
with a moving ball bearing centered in the circular top.
Heim joints are used in a
variety of applications. Suspension, heim joints can be used as the linkage of
you upper and lower control arms. Steering, heims can be used on drag links, or
tie rods. As far as vehicle applications anything that pivots or moves back and
forth, a heim joints can be used So for
those of us that are looking at parts for crawling, wheeling (both slang terms
for driving off-road over obstacles), or building up our suspension. Heim
joints are a great way to go.
Heim joints are helpful
in precisely locating your wheels. The precise location of your wheels is a
huge part of 4wd suspension. For example if you have one tire on the ground and
another on a boulder, knowing where that tire is landing and how it’s going to
move over that obstacle is a huge advantage! To be successful in clearing the
obstacle and bragging to all your friends about how you just dominated it.
A lot of questions we get
are about the dimensions of our heims. So let’s take for example our 7/8” x ¾”
Heim Joint.
The 7/8 is the thread size of the threaded shank.
The ¾ is the diameter of the bore hole.
Now what do we do with
this heim joint. What most of our customers do is put this into a tube insert
that has been welded into a piece of D.O.M tubing (steel piece of pipe).
This bring me to another
frequently asked question. What tube insert do I need? We can continue using
this 7/8 x ¾ heim for our example.
Tube inserts can come in
a variety of sizes as well. For this example we will need a 7/8 tube insert so
that the diameter of our heim matches our tube insert. We offer a variety 7/8
tube inserts with different outer diameters. The outer diameters are different
so that you can insert our tube inserts into different sizes of tubing.
Confused yet?
Here is how we sell tube
inserts and what all the numbers mean broken down.
TUBE INSERT (7/8-14) FOR 1 1/2" ID TUBE
7/8 -14 Thread Size of tube insert. (Not inner diameter of tubing.)
For 1 ½” Id Tube this
means the tube that you can put this insert in needs to have an inner diameter
of 1 ½” inches.
Now your 7/8” diameter heim will fit into your 7/8”
tube insert, and your 7/8” tube insert with 1 ½” Outer diameter, Will fit
into any tubing with 1 ½” inner diameter.
The tube insert will be welded into your pipe. The heim will then be screwed into the tube insert. A jam nut can be placed on the heim to prevent loosening before screwing it into the tube insert. Your finished product will look like this.
Hopefully this helps us
understand Heim Joints a little better. In my next blog we will get into how to
make heim joints move and grove with Misalignment spacers. Shoot me some
questions about this blog I will definitely try to answer them all.
0 Comments
Mel Saxby
This was very helpful to me I was told I needed heim joins for my project, but until I read this, I had no idea what sizes I should buy. Not only that! Your prices are (much!) better than other places I looked.