This is one of my renditions of the common Curved Shock Tab. It is very usefull in getting the shock out of the way or low mounting with the bridge for a little protection. By joining 2 tabs together to make a bracket, the bridge between tabs also makes the combination more than twice as strong as when used individually. These are cut for a 1.75" tube because Tube frames always seem to be the most crowded but you can use it anywhere. And it saves 15 minutes over single tabs every time. If you are a shop, you need every time saver you can get to decrease work backlog and keep making money, and so much better when it is stronger too. These make tab placement accurate, easy, and fast, period. .25" (1/4) HRP&O Steel, sold in pairs.