This is our idea of the correct way to make an Offset Panhard / Trackbar bracket, it seems like 3 out of 4 need to be on the laeding edge of the axle for clearance issues. It has 3 mounting position options, 5.5", 6'5", & 7.5" from Axle center. They are cut to a 3" axle tube radius so they can be made to fit any tube diameter & made from 1/4" plate too and bent perfectly so you don't have to play with the grinder to make them fit! They have a reinforcement plate also cut to the axle bias with 2 drain holes built in. If it ends up that the the low hole is what you need just just cut off the excess. These are setup for a 2" ID so just about any heim will fit with minimal missalignment. 9/16" holes.